Level 3 Award in the Installation and Maintenance of Heat Pump Systems (Non-refrigerant Circuits)
3 - 4 Days
There are no download types with downloads for this product.
Description
The course is designed to provide practicing installers the skills and knowledge required to determine the most appropriate Heat Pump system for an installation and, through consultation with the client about their needs and demands, install any of the common Air Source or Ground Source Heat Pump in a safe and effective manner.
The heat pump installer course will demonstrate your ability to install and maintain Heat Pump Systems. The course is aimed at candidates with experience (5 years or more) in plumbing or conventional heating engineering, an NVQ level 3 in plumbing, heating engineering or equivalent. It is also open to those in the process of gaining these qualifications.
The course is designed to provide practising installers the skills and knowledge required to determine the most appropriate heat pump for an installation and through consultation with the client about their needs and demands, install any of the common ground source or air source heat pump types in a safe and efficient manner.
The course is assessed via both practical and theory examinations.
See the course structure to decide which course suits your needs & requirements for your trade.
3-Day Course Structure (Air Source Only)
Over the 3 days course you will receive both practical and theoretical training in the following areas:
- Know the requirements to install, commission and hand over Air Source Heat Pump systems.
- Install, commission and handover Air Source Heat pump systems.
- Know the requirements to inspect, service and maintain Air Source Heat Pump systems.
- Inspect, service and maintain Air Source Heat Pump systems.
4-Day Course Structure (Air Source and Ground Source)
Over the 4 days course you will receive both practical and theoretical training in the following areas;
- Know the requirements to install, commission and hand over Air and Ground Source Heat Pump systems.
- Install, commission and handover Air and Ground Source Heat pump systems.
- Know the requirements to inspect, service and maintain Air and Ground Source Heat Pump systems.
- Inspect, service and maintain Air and Ground Source Heat Pump systems.
Who Can Attend?
Who should attend?
Candidates should hold and evidence at least one of the below in addition to if not included in the below certification WRAS Water Regulation, Water Byelaws or equivalent.
- N/SVQ level 2/3 in plumbing or equivalent earlier certification that provides evidence of competence;
- or N/SVQ level2/3 in heating and ventilation (Domestic Installation) or equivalent earlier certification that provides evidence of competence;
- or N/SVQ level2/3 in heating and ventilation (industrial and commercial) or equivalent earlier certification that provides evidence of competence;
- or N/SVQ level2/3 in Oil Fired Technical Services or equivalent earlier certification that provides evidence of competence
- or N/SVQ level2/3 in Gas installation and maintenance or equivalent earlier certification that provides evidence of competence;
- or Heating installers with minimum 3 years of experience installing wet central heating systems, evidence either by Manufacturer courses certification or Gas Safe register, OFTEC, MCS, HETAS registration.
In addition, if not included in the above certification in relation to:
- WRAS Water Regulations
Required Materials
- Candidates must bring 2 x passport photos and proof of their course pre-requisites.
- You will receive an BPEC Heat Pump Systems Manual included in the cost of the course.
Recently Viewed
There are no recently viewed products.